Bombardier SeaDoo 2000 factory shop manual volume 1, Page 219Get this manual
Section 06 FUEL SYSTEM Subsection 05 (FUEL INJECTION)
Check also the resistance between terminal (BLACKBROWN wire) and terminal 11 (WHITE BROWN wire) with the throttle plate in idle positionThe resistance should be between 710 and 1380
Depress the startstop button with the safety lanyard removed to activate the timerThere should be Vdc
Crankshaft Position Sensor (CPS)
Check the resistance of the crankshaft position sensorF07F15B
F07H0CA
If resistance is below specifications, replace the throttle position sensor (TPS)If resistance is above specifications, disconnect the connector of the throttle position sensor and check resistance of wiring harness and terminals between AMP plug connector and TPS sensor connectorIf there is an open circuit, repair or replace the defective wire or terminalReconnect the throttle position sensor connector and recheck resistance values at AMP plug connector number 4If not within specification, replace the throttle position sensorNOTE: Whenever the TPS is replaced, removed or adjusted, the TPS closed position must be readjustedVoltage Test If the sensor resistance value is good, check the voltage output from MPEM to throttle position sensorDisconnect plug connector from throttle position sensor and connect voltmeter between the PURPLEBROWN wire and the BLACKBROWN wire in the wiring harness