Bombardier SeaDoo 2000 factory shop manual volume 1, Page 187Get this manual
Section 06 FUEL SYSTEM Subsection 02 (FUEL CIRCUIT)
NOTE: fuel tank is comprised of components: the tank, the fuel pick up neck and the filler neckThe necks are injection molded and the tank is then blow molded over the necksDuring the molding process, small molding seam may appear on the inner side of the necks at approximately mm (532 in) from the base of the neckIt is normal situation to have molding seam and it should not be confused with crack
FUEL SYSTEM PRESSURIZATION
WARNING
Whenever doing any type of repair on watercraft or if any components of the fuel system are disconnected, pressure test must be done before starting engineEnsure to verify fuel line ends for damageAlways cut damaged end before reinstallation
ASSEMBLY
Assembly is essentially the reverse of disassembly proceduresHowever pay particular attention to the following
Pressure Test
All Models Proceed as follows: Fill up fuel tank Disconnect air inlet hose of fuel tank from body Install hose pincher (PN 295 000 076) on fuel tank vent hose