Bombardier SeaDoo 2000 factory shop manual volume 1, Page 155Get this manual
Section 04 ENGINE Subsection 08 (EXHAUST SYSTEM)
947 Engine Apply Molykote 111 on threads of Allen screws no12Install and hand tighten Allen screws no12 as per following picture
CAUTION: Damage to bushings andor sleeve will eventually cause stress to tune pipe and may cause crackingMake sure that gasket no16 is properly located on exhaust manifold prior to finalizing pipe installationApply Loctite 243 (blue) on nut no8 and screws no6 and no7Hand tighten all fasteners before torquing any of themFor torquing specifications, see the main illustrations at the beginning of this subsectionInstall tuned pipe cone no5 with collar no15 and clamp no4Position clamp no4 as illustratedDo not tighten clamp yet
F06D1YA
1M10 60 Allen screws 2M10 110 Allen screws
Torque Allen screws to 24 Nm (17 lbfft) as per following illustrated sequenceRepeat the procedure, retightening Allen screws to 40 Nm (30 lbfft)8 6