Bombardier SeaDoo 2000 factory shop manual volume 1, Page 117Get this manual
Section 04 ENGINE Subsection 06 (BOTTOM END)
DISASSEMBLY
Engine has to be removed from watercraft and top end has to be disassembled to open bottom endRefer to REMOVAL AND INSTALLATION and TOP END
PTO Flywheel
717 Engine To remove PTO flywheel no1, the crankshaft must be lockedRefer to MAGNETO SYSTEM and follow the procedure to lock the magneto flywheelPTO flywheel is loosen using PTO flywheel remover (PN 295 000 001)F00D0ZA
TYPICAL 1Extension handle locking crankshaft
NOTE: When splines of PTO flywheel are worn out and special tool cannot be used, proceed with the following alternate methodUse pipe wrench and install it on PTO flywheel as illustrated