Bombardier SeaDoo 2000 factory shop manual volume 1, Page 101Get this manual
Section 04 ENGINE Subsection 05 (TOP END)
The needles, thrust washers and the sleeve remain in the connecting rod bore and may be used again1 2
The inspection of engine top end should include the following measurementsENGINE MEASUREMENT Cylinder taper Cylinder out of round Pistoncylinder wall clearance for the 717 engine TOLERANCES NEW PARTS (MIN (MAX N.AN.A0.10 mm (.0039 in) 0.13 mm (.005 in) 0.09 mm (.0035 in) 0.025 mm (.001 in) 0.025 mm (.001 in) 0.048 mm (.002 in) 0.25 mm (.001 in) 0.40 mm (.016 in) 0.45 mm (.018 in) 0.05 mm (.002 in) 0.008 mm (.0003 in) N.AWEAR LIMIT 0.1 mm (.004 in) 0.08 mm (.003 in) 0.20 mm (.008 in) 0.22 mm (.009 in) 0.20 mm (.008 in) 0.20 mm (.008 in) 0.24 mm (.009 in) 0.20 mm (.008 in) 1.0 mm (.039 in) 1.0 mm (.039 in) 1.0 mm (.039 in)
F00B0NA
1Needles and thrust washer 2Sleeve