Bombardier SeaDoo 2000 factory shop manual volume 1, Page 98Get this manual
Section 04 ENGINE Subsection 05 (TOP END)
Cylinder
787 RFI Engine Remove air intake silencer and support, refer to AIR INTAKE717 and 787 RFI Engines Remove tuned pipe and exhaust manifold, refer to EXHAUST SYSTEMRemove screws no13Remove cylinders no9, being careful that connecting rods do not hit crankcase edge
Remove cylinder block no9
WARNING
If screws need to be heated for removal when engine is in watercraft, fuel system pressurization must be done firstDo not use open flame; use heat gunNOTE: Even if only cylinder needs repair, both cylinders should be lifted to allow 1-piece cylinder base gasket replacement947 Engine Remove studs no32Take two head cover nutsScrew nuts onto studLock both nuts together and unscrew the studRepeat this operation for the other studsNOTE: Studs must be removed prior cylinder blockF06D0ZA