Bombardier SeaDoo 2000 factory shop manual volume 1, Page 84Get this manual
Section 04 ENGINE Subsection 04 (MAGNETO SYSTEM)
Battery Charging Coil
Position new coil, crimp and solder all wiresPrior to assembly, apply Loctite 243 (blue)Use magneto coil centering tool (PN 420 876 922) and install it so that it fits around armature plate before tightening screws no23F00D0AA
1Magneto coil centering tool (PN 420 876 922)
Magneto Flywheel and Ring Gear
Apply Loctite 648 (green) to magneto flywheel mating surfaceLay ring gear on steel plate, then heat with propane torch in order to install it on magneto flywheelPay particular attention to position ring gear teeth chamfer side as per following illustration
NOTE: Ensure that ring gear contacts magneto flywheel flangeWhenever replacing either ring gear or magneto flywheel, Gun Kote must be applied to prevent possible corrosionCAUTION: Always assemble magneto flywheel and ring gear prior to apply Gun KoteIf not done correctly, ring gear won't contact magneto flywheel flangeTo apply Gun Kote proceed as follows: 1Clean thoroughly and degrease replacement part using non oil base solvent2Apply coating in light thin coats using spray gunNOTE: Do not spray Gun Kote into magneto flywheel threaded holes3Bake parts in oven at 175C (350F) for hour to cure Gun KoteCAUTION: Do not eliminate Gun Kote heat curing time because it will lose all its resistance and it will not give any protection