Bombardier SeaDoo 2000 factory shop manual volume 1, Page 81Get this manual
Section 04 ENGINE Subsection 04 (MAGNETO SYSTEM)
If desired, magneto rotor no8 can be removed without removing the engine flywheel no3Remove the six screws no17
Insert crankshaft protector to outer end of crankshaft and fully thread puller in engine flywheel
F01D7YA F01D7XA
1Puller
NOTE: Remove crankshaft position sensor no18 before removing the flywheel1
Tighten puller screw and at the same time, tap on screw head using hammer to release engine flywheel from its taper
Magneto Housing