Bombardier SeaDoo 2000 factory shop manual volume 1, Page 48Get this manual
Section 02 MAINTENANCE Subsection 05 (STORAGE)
Battery
For battery removal, cleaning and storage, refer to CHARGING SYSTEM
NOTE: The engine will not have to run during this operationAir Pressure Method Install an air pressure adaptor to the water outlet located at the rear of the watercraftConnect the air pressure hose to the air pressure adaptor and open air pressure circuitThe air pressure will expell all water out of engineWater and Antifreeze Method Install hose pincher to engine drain hose near the PTO flywheel guardThe engine drain hose in generally the lowest water hose coming out of the engine1 2
Watercraft Cleaning
Clean the bilge with hot water and mild detergent or with bilge cleanerRinse thoroughlyLift front end of watercraft to completely drain bilgeIf any repairs are needed to body or to the hull, touch up paint and Gelcote repair kit are availableReplace damaged labelsdecalsWash the body with soap and water solution (only use mild detergent)Rinse thoroughly with fresh waterRemove marine organisms from the hullApply nonabrasive waxCAUTION: Never clean fiberglass and plastic parts with strong detergent, degreasing agent, paint thinner, acetone, etcIf the watercraft is to be stored outside, cover it with an opaque tarpaulin to prevent sun rays and grime from affecting the plastic components, watercraft finish as well as preventing dust accumulationCAUTION: The watercraft must never be Ieft in water for storageNever leave the watercraft stored in direct sunlight