Bombardier SeaDoo 1999 factory shop manual, Page 339Get this manual
Section 09 PROPULSION SYSTEM Subsection 03 (DRIVE SYSTEM)
XP Limited
Rear Drive Shaft
Remove rear access panelRemove protective plate no18
F01I05A
1Use ball end mill for radiusThis section of the slot should be 38 mm (1-1532 in) deep 2Drill 25 mm (1 in) hole in center to remove material 3Weld all around 4Drill mm (1132 in) hole 5Drill through mm (1132 in) 6Drill and tap mm (14 in) holes A305 mm (12 in) B105 mm (4-18 in) C16 mm (58 in) D51 mm (2 in) E36 mm (1-2564 in) F22 mm (78 in) G17 mm (4364) H19 mm (34 in) I35 mm (1-38 in) J20.3 mm .18 (.800 in .007)