Bombardier SeaDoo 1998 factory shop manual, Page 368Get this manual
Section 12 HULLBODY Subsection 02 (ADJUSTMENT AND REPAIR)
Remove protective caps no18 and loosen screws no19 to remove eyelet no20 on each side of seat
SEAT COVER REPLACEMENT
Install staples with an electric tacker such as Arrow tacker noETN-50 or with manual tacker such as Arrow tacker noT-50NOTE: For an easier installation, it's highly recommended to use an electric tackerEnsure that the seat rest firmly against hard surface such as piece of woodThis is done to get the staples completely pushed in place
F08L1EA
1Loosen screws of eyelet
Remove cup no21 on each side of seatLoosen nut no23 on each side of seat1
F01L3YA