Bombardier SeaDoo 1998 factory shop manual, Page 313Get this manual
Section 09 PROPULSION SYSTEM Subsection 05 (VARIABLE TRIM SYSTEM)
GENERAL
To test VTS control module, motor or switch, refer to INSTRUMENTS AND ACCESSORIES 08-05
Disconnect wires of motorRemove retaining nuts no11REMOVAL
Disconnect ball joint no1Remove clamps no2Remove boot no3To loosen nut no4, use VTS socket tool (PN 295 000 133)
F01J1XA
1Remove nuts 2Disconnect wires
F01B2PA
Pull on motor to remove it
Remove sealing washer no5
SPX Model Remove the spacer no17All Models Disconnect wiring harnessesPull out VTS assembly no6 from bilge