Bombardier SeaDoo 1998 factory shop manual, Page 305Get this manual
Section 09 PROPULSION SYSTEM Subsection 04 (REVERSE SYSTEM)
2, Spring
Insert spring in lever stem hole and then install curved end in sliding block groove
ADJUSTMENT
7, Reverse Gate
Position handlebar in straight ahead position, nozzle should be parallel to rear of watercraftUsing square, set it to 129 mm (5-564 764 in), then position square end at the top middle of nozzleF02J0KA
TYPICAL 1Sliding block groove
Shift Lever Lubrication
Lubricate sliding block support sliding area and triangular lever with synthetic greaseAlso, lubricate sliding washer and shift lever stem2