Bombardier SeaDoo 1998 factory shop manual, Page 297Get this manual
Section 09 PROPULSION SYSTEM Subsection 03 (DRIVE SYSTEM)
3, Drive Shaft
Install drive shaft and jet pump at the same time
SPX, GS, GTS and GTI Models Insert drive shaft through carbon ring no8 and floating ring no6NOTE: Make sure to install floating ring before inserting the drive shaft in the PTO flywheelGSX Limited and GTX Limited Insert drive shaft through seal carrier no14 being careful not to damage seals
F05I0EA
CAUTION
Step 1: Torque to Nm (26 lbfin) as per sequence Step 2: Torque to 10 Nm (88 lbfin) as per sequence
23,24, Damper and Bushing
Make sure to install dampers and bushing
When sliding the drive shaft through seal carrier, the double lip seal can be folded overThis would cause seal carrier bearing failure
All Models Except the XP Limited While holding jet pump, guide and engage drive shaft splines in PTO flywheelRotate shaft to properly index splinesMake sure boot is well positioned over shaft endXP Limited