Bombardier SeaDoo 1998 factory shop manual, Page 284Get this manual
Section 09 PROPULSION SYSTEM Subsection 02 (JET PUMP)
SPX and GTS Models Secure water supply hose and both bailer tubes to jet pump housing using tie raps
WARNING
Whenever removing screw always renew locking disksScrew must be torqued as specified
SPX, GSX Limited, and XP Limited Install nozzletrim ring assemblyTorque screws to 14 Nm (10 lbfft)NOTE: Trim ring has tight fit; to install, insert both sides at the same time, taking care not to break plastic bushingsCarefully use plastic tip hammer if necessaryMake sure steering arm of jet pump is on right side and trim arm is above venturi
F01J0IA
1Bailer tubes 2Water supply hose
Reinstall air vent tube support onto body (SPX model)