Bombardier SeaDoo 1998 factory shop manual, Page 282Get this manual
Section 09 PROPULSION SYSTEM Subsection 02 (JET PUMP)
Apply Loctite 518 (Gasket Eliminator) on mating surfacePosition venturi with bailer passages on topApply Loctite 242 (blue) on threads of screws no12NOTE: On the GTI and GTX models, install the reverse support with the venturiInstall screws no12, lock washers no13 and flat washers no14 then torque to 21 Nm (16 lbfft)Proceed as follows: Remove drain plug from cover Apply Loctite PST 592 on threads of fitting tool (PN 295 000 086) then secure on cover Connect pump gauge tester (PN 295 000 085) to fitting Pressurize pump to maximum of 70 kPa (10 PSI)
F00J0LA
F02J0TA
Pump must maintain this pressure for at least 10 minutes
1Torque screws to 21 Nm (16 lbfft)