Bombardier SeaDoo 1998 factory shop manual, Page 278Get this manual
Section 09 PROPULSION SYSTEM Subsection 02 (JET PUMP)
Bearing on impeller side must be 1.5 to 2.5 mm (.060.100 in) inside reservoir measured from seal seatBearing on venturi side must be to mm (.080.120 in) inside reservoir measured from thrust washer seatRefer to following illustration-
CAUTION
Prevent sealant from contacting any needles of bearingPush on tool end with press until tool flange contacts housing
F01J1JA
Seal seat Stamped end of bearing Thrust washer seat Stamped end of bearing 1.52.5 mm (.060.100 in)mm (.080.120 in)
F00J0CA