Bombardier SeaDoo 1998 factory shop manual, Page 225Get this manual
Section 08 ELECTRICAL SYSTEM Subsection 02 (IGNITION SYSTEM)
Primary Winding
DYNAMIC TEST
GTS Model Due to the integrated CDI module, it is not possible to take any resistance measurementAll Other Models 1Remove the female spade connectors from the primary side of the ignition coil2With the multimeter set on the resistance scale, connect the meter probes to the primary terminals of the coil3Resistance should be between 0.340.62 ohmSecondary Winding The spark plug caps must be removed from high tension cables, because they are resistor capsThe cap resistance is 4.48 ohms1 2
All Models Except GTS Use an ignition coil tester, available from aftermarket toolequipment suppliers-
CAUTION
Do NOT use coil tester on metal work benchFollow manufacturer instructions1With ignition coil removed from craft, disconnect spark plug caps from high tension cables2Hook high tension leads from tester to ignition coil high tension cables3Connect smaller tester leads to primary of ignition coilON OFF 12 V