Bombardier SeaDoo 1998 factory shop manual, Page 224Get this manual
Section 08 ELECTRICAL SYSTEM Subsection 02 (IGNITION SYSTEM)
DYNAMIC TEST 1Connect spark plug cables to grounding device2Disconnect magneto wiring harness connector3Install the 4-pin magneto harness adapter (PN 295 000 131)4Connect positive test probe of the multimeter to the REDBLACK wire of the 4-pin magneto harness adapter5Connect negative test probe of the multimeter to BLACK wire of the 4-pin magneto harness adapter6Set multimeter to Vac scale7Crank engine and note resultThe obtained value should be between 18 and 25 Vac8If the generating coil is out of specification, replace itNOTE: If the generating coil tests good, disconnect the primary wires of the ignition coilCrank engine and check voltage at primary wiresIt should be at least 20 VdcIf there is insufficient or no voltage, either the MPEM or wiring harness is defective
F01H5YA
Multimeter Six-pin magneto harness adapter WHITE wire BLACKYELLOW wire
Trigger Coil Verification