Bombardier SeaDoo 1998 factory shop manual, Page 208Get this manual
Section 07 LUBRICATION SYSTEM Subsection 03 (OIL INJECTION PUMP)
If not, remove pump assembly and check the pump gear (717 engine) or shaft (787 and 947 engines) for defects, replace as necessaryTest pump as describes below: NOTE: Through normal use, oil level must not drop in small tubesIf oil drops, verify check valve operationReplace as necessary
Bench Test
The oil pump must be removed out of watercraftConnect hose filled with injection oil to main line fittingInsert other hose end in an injection oil containerUsing counterclockwise (reverse position) rotating drill rotate pump shaftOil must drip from fittings in parts of rotary valve cover while holding lever in fully open position2
F07G02A
787 and 947 ENGINES 1Bleed screw
Keep bleeding until all air has escaped from lineMake sure no air bubbles remain in oil supply lineTighten bleed screwWipe any oil spillageCheck small oil lines of pumpThey must be full of oilIf not, run engine at idle speed while manually holding pump lever in fully open positionDo not activate throttle lever-