Bombardier SeaDoo 1998 factory shop manual, Page 184Get this manual
Section 06 FUEL SYSTEM Subsection 04 (CARBURETOR)
CLEANING
The carburetor exterior surfaces should be cleaned with general solvent and dried with compressed air before disassembly-
CAUTION
Be careful at carburetor cleaning not to remove paintPaint removal will cause carburetor to rust very rapidlyRepaint if necessaryCarburetor body and jets should be cleaned with carburetor cleanerFollow manufacturer's instructions
F01F0XA
WARNING
Solvent with low flash point such as gasoline, naphtha, benzol, etc should not be used as they are flammable and explosive
TYPICAL 1Pump gauge tester 2Install on pulse nipple
Diaphragm must stand pressure for 10 secondsIf pressure drops, replace diaphragm
CAUTION
4, Pump Body