Bombardier SeaDoo 1998 factory shop manual, Page 131Get this manual
Section 04 ENGINE Subsection 07 (ROTARY VALVE)
8, Bearing
To remove bearing use bearing extractor such as Snap-on no CJ-950 as illustratedSlide off distance sleeve, remove snap ring no7 and press shaft out
Snap-on hammer puller including: Handle CJ93-1 Hammer CJ125-6 Claws CJ93-4
F01J0ZA
F01D4NA
1Bearing 2Bearing extractor Snap-on CJ-950
Close puller claws so that they can be inserted in end bearingHolding claws, turn puller shaft clockwise so that claws open and become firmly tight against bearingSlide puller sleeve outwards and tap puller endRetighten claws as necessary to always maintain them tight against bearingContinue this way until bearing completely comes out1