Bombardier SeaDoo 1998 factory shop manual, Page 119Get this manual
Section 04 ENGINE Subsection 06 (BOTTOM END)
NOTE: Distance should be the same on both sidesBent stopper as required to obtain the proper distance
ASSEMBLY
Assembly is essentially the reverse of disassembly proceduresHowever pay particular attention to the following
3,4, Crankshaft and Bearing
Apply Loctite 767 anti-seize on part of crankshaft where bearing fitsPrior to installation, place bearings into container filled with oil, previously heated to 75C (167F)This will expand bearing and ease installationTo properly position the outer bearing(s), distance gauge must be temporarily installed against the inner bearingSlide the outer bearing until stopped by the distance gauge, then remove itENGINE 717 787 947 DISTANCE GAUGE PN 529 034 800 (PTO) PN 529 034 900 (MAG) PN 290 876 627 (MAG) PN 290 876 622 (PTO)