Bombardier SeaDoo 1998 factory shop manual, Page 91Get this manual
Section 04 ENGINE Subsection 05 (TOP END)
The inspection of engine top end should include the following measurements1 2
ENGINE MEASUREMENT Cylinder Taper Cylinder Out of Round PistonCylinder Wall Clearance for the 717 Engine PistonCylinder Wall Clearance for the 787 Engine PistonCylinder Wall Clearance for the 947 Engine RingPiston Groove Clearance Ring End Gap
N.A Not Applicable
TOLERANCES NEW PARTS (min (max N.AN.A0.10 mm (.0039 in) 0.11 mm (.0043 in) 0.09 mm (.0035 in) 0.03 mm (.001 in) 0.40 mm (.016 in) 0.05 mm (.002 in) 0.008 mm (.0003 in) N.AWEAR LIMIT 0.1 mm (.004 in) 0.08 mm (.003 in) 0.20 mm (.008 in) 0.20 mm (.008 in) 0.20 mm (.008 in) 0.20 mm (.008 in) 1.0 mm (.039 in)
F00B0NA
1Needles and thrust washer 2Sleeve