Bombardier SeaDoo 1998 factory shop manual, Page 72Get this manual
Subsection 04
Section 04 ENGINE (MAGNETO SYSTEM)
13, Battery Charging Coil
Position new coil, crimp and solder all wiresPrior to assembly, apply Loctite 242 (blue)Use magneto coil centering tool (PN 290 876 922) and install it so that it fits around armature plate before tightening screws no14Whenever replacing either ring gear or magneto flywheel, Gun Kote must be applied to prevent possible corrosion-
CAUTION
Always assemble magneto flywheel and ring gear prior to apply Gun KoteIf not done correctly, ring gear won't contact magneto flywheel flangeTo apply Gun Kote proceed as follows: 1Clean thoroughly and degrease replacement part using non oil base solvent2Apply coating in light thin coats using spray gunNOTE: Do not spray Gun Kote into magneto flywheel threaded holes3Bake parts in oven at 175 (350F) for hour to cure Gun Kote
F00D0AA
1Magneto coil centering tool (PN 290 876 922)
4,5, Magneto Flywheel and Ring Gear
Apply Loctite 648 (green) to magneto flywheel mating surfaceLay ring gear on steel plate, then heat with propane torch in order to install it on magneto flywheelPay particular attention to position ring gear teeth chamfer side as per following illustration