Bombardier SeaDoo 1998 factory shop manual, Page 55Get this manual
Section 04 ENGINE Subsection 03 (REMOVAL AND INSTALLATION)
REMOVAL AND INSTALLATION
GENERAL
It is not necessary to remove engine from watercraft to service TOP END, PTO FLYWHEEL or MAGNETOHowever, engine removal is necessary to repair BOTTOM END
All Models Disconnect temperature switch wire and spark plug cablesDisconnect magneto wiring harness
ENGINE REMOVAL
In order to remove engine from watercraft proceed as follows-
CAUTION
Whenever removing engine from watercraft, enginejet pump alignment must be performed at reinstallation
Jet Pump Removal
To withdraw jet pump, refer to JET PUMP 09-02F01D8RA