Bombardier SeaDoo 1997 factory shop manual, Page 256Get this manual
Section 09 STEERING SYSTEM Sub-Section 02 (SP AND SPX MODELS)
REMOVAL AND INSTALLATION
To replace the cover, loosen set screws no19 of handlebar housingWhen installing the grip insert in the handlebar no12, ensure that its notch is properly inserted in the hole beneath the handlebarInstall grip no4 on handlebar no12 matching it to the hex form on the grip insertInstall flat washer no7 and screw no6Torque screw to 14 Nm (10 lbfft)Install cap no5
F00K01A
1Set screw
F01K1PA
Remove and reinstall screws no2 and washers no31 2