Bombardier SeaDoo 1997 factory shop manual, Page 251Get this manual
Section 08 PROPULSION SYSTEM Sub-Section 05 (VARIABLE TRIM SYSTEM)
GENERAL
To test VTS control module, motor or switch, refer to ELECTRICAL SYSTEM 07-05
REMOVAL
Disconnect ball joint no1Loosen gear clamps no2Remove boot no3To loosen nut no4, use VTS socket tool (PN 295 000 133)F01J1XA
1Remove nuts 2Disconnect wires
Pull on motor to remove it
9,10, Worm and Sliding Shaft
F01B2PA
Pull out VTS assembly no6 from bilge
Simply pull on worm and sliding shaft in order to remove them