Bombardier SeaDoo 1997 factory shop manual, Page 232Get this manual
Section 08 PROPULSION SYSTEM Sub-Section 03 (DRIVE SYSTEM)
5,18, Floating Ring and O-ring
Inspect condition of O-rings and floating ring contact surfaceXP and HX Models Only
14, Needle Bearing
Properly support seal carrier when installing seals and bearing-
CAUTION
Ensure to install stamped end of bearing (showing identification markings) first on toolNever hammer the bearing into its housing2
Install bearing with the bearingseal installer tool (PN 295 000 107)
F01I0GA
1O-rings 2Floating ring contact surface
Check also condition of drive shaft O-ringReplace as necessary
All Models Except the XP and HX