Bombardier SeaDoo 1997 factory shop manual, Page 207Get this manual
Section 08 PROPULSION SYSTEM Sub-Section 02 (JET PUMP)
GTI and GTX Models Remove reverse gate and supportAll Models Pull nozzle and venturi from impeller housingNOTE: On the GTS model, the venturi and reverse gate are removed as an assemblyRemove plug from cover
F02J0TB
1Screws
F01J5IA
TYPICAL 1Remove plug
Check oil level, it should be at bottom of hole threadsIf oil level is low, check impeller shaft housing for leaksA pressure test must be performedRefer to PUMP PRESSURIZATION in this sectionTo check oil condition, insert wire through oil level hole then withdrawA whitish oil indicates water contaminationThis may involve defective impeller shaft seal andor O-ring of housing coverJet pump unit should be overhauled to replace sealIf everything is correct, apply Loctite PST 592 on plug and reinstall it on coverProperly reinstall removed parts