Bombardier SeaDoo 1997 factory shop manual, Page 152Get this manual
Section 06 LUBRICATION SYSTEM Sub-Section 03 (OIL INJECTION PUMP)
All Engines Start and bring engine to normal operating temperature
717 Engines
CAUTION
If watercraft is out of water, engine must be cooled using the flush kitIf air bubbles are present in the oil injection system, bleed system before operating engineAdjust idle speed to specificationRefer to FUEL SYSTEM 05-04Stop engine
Final Synchronization
Eliminate throttle cable free-play by depressing throttle lever until slight resistance is feltIn this position, marks on pump body and lever must alignNOTE: mirror may be used to facilitate this verificationIf necessary, turn cable adjustment screw to obtain pump mark alignmentRefer to above illustrationsTighten jam nut and recheck alignment marks