Bombardier SeaDoo 1997 factory shop manual, Page 48Get this manual
Sub-Section 04
Section 03 ENGINE (MAGNETO SYSTEM)
Whenever replacing either ring gear or magneto flywheel, Gun Kote must be applied to prevent possible corrosion
14, Trigger Coil
Install the trigger coil in magneto housing cover no1 and torque screws no15 to 10 Nm (88 lbfin)NOTE: The trigger coil is not adjustable-
CAUTION
Always assemble magneto flywheel and ring gear prior to apply Gun KoteIf not done correctly, ring gear won't contact magneto flywheel flangeTo apply Gun Kote proceed as follows: 1Clean thoroughly and degrease replacement part using non oil base solvent2Apply coating in light thin coats using spray gunNOTE: Do not spray Gun Kote into magneto flywheel threaded holes3Bake parts in oven at 175 (350F) for one hour to cure Gun Kote
F06D0DA
CAUTION
1Trigger coil
Do not eliminate Gun Kote heat curing time because it will lose all its resistance and it will not give any protection