Bombardier SeaDoo 1997 factory shop manual, Page 37Get this manual
Section 03 ENGINE Sub-Section 03 (REMOVAL AND INSTALLATION)
Loctite 242
F01D7RA F00D0BA
TYPICAL 787 ENGINE
TYPICAL 1Torque to 35 Nm (26 lbfft)
CLEANING
Wipe off any spillage in bilgeClean with bilge cleanerClean external parts of engine
Four-Piece Engine Support Torque front and rear engine supports as shown in the following illustration
INSTALLATION
Installation of engine in watercraft is essentially the reverse of removal proceduresHowever pay particular attention to the following
Rubber Mount, Shim and Screw
Check tightness and condition of rubber mountsIf they have been removed, apply Loctite 242 (blue) on screw threadsTorque screws to 25 Nm (18 lbfft)F02D09A
Loctite 242