Bombardier SeaDoo 1996 factory shop manual, Page 259Get this manual
Section 10 STEERING SYSTEM Sub-Section 02 (GTS AND GTI MODELS)
TO INSTALL HANDLEBAR ASSEMBLY14, Grommet
Insert throttle cable through dashboard hole and slide grommet on cableInsert grommet in dashboard hole and pull it from inside bilgeNOTETo ease installation, apply water on grommetInsert wires of monitoring beeper and startstop button2 4
F01K0VA
15,16,17,18, Spring Washer, Shim, Steering Stem and Support
Insert spring washer and the shim onto steering stemInsert steering stem into support
TYPICAL 1Steering stem arm 2Steering stem tenon 3Mortise 4Large flat washer with 5Lock washer 6Screw, apply Loctite 271 and torque to 40 Nm (30 Ibfft)
Position mm flat washer on steering stopper screw then install locking plate over steering stem head screwNOTEEnsure locking plate slot is inserted in steering stopper screwInstall mm flat washer and secure locking plate using jam nutTorque to Nm (62 Ibfin)