Bombardier SeaDoo 1996 factory shop manual, Page 254Get this manual
Section 10 STEERING SYSTEM Sub-Section 01 (SP XP SERIES)
While performingCAUTION :precautions to avoidthis procedure, take damaging throttle cable and wiring harnessesTo install handlebar assembly: Installation is essentially the reverse of removal proceduresHowever, pay particular attention to the following2
F01K1QA
13,14,15, Thrust Ring, Rear and Front Supports
Lubricate with synthetic grease thrust ring of rear and front supports
Grip insert Grip Flat washer Loctite 242 (blue) Torque bolt to Nm (53 lbfin) Cap
9,10,11,12, Steering Stem, Arm, Support and Handlebar
To remove handlebar assembly: Disconnect wiring harnesses leading out of steering stemDisconnect throttle cable at carburetorRemove throttle cable from tie-blocksUnscrew bolts retaining support to steering stem arm