Bombardier SeaDoo 1996 factory shop manual, Page 243Get this manual
Section 09 PROPULSION SYSTEM Sub-Section 03 (REVERSE SYSTEM)
2, Spring
Insert spring in lever stem hole and then install curved end in sliding block groove
Using square, set it to 129 mm (5-564 7 64 in), then position square end at the top middle of nozzleF02J0HA F02J0KA
TYPICAL 1Sliding block groove
A129 mm (5-564 764 in)
Pull selector lever to REVERSE position1
Selector Lever System Lubrication
Lubricate sliding block support sliding area and triangular lever with synthetic greaseAlso, lubricate sliding washer and selector lever stem2