Bombardier SeaDoo 1996 factory shop manual, Page 235Get this manual
Section 09 PROLPUSION SYSTEM Sub-Section 02 (DRIVE SYSTEM)
NOTEBearing can also be installed with the same driver used at disassemblyCenter bearing in longitudinal axis of housingPush seals until tool comes in contact with housing
F01J2TA
1Push bearing centered in its housing
F01J1YA
Install double-lip seal with protector toward impeller sideOn both seals, raised edge of lip must be located outwards of seal carrier
TYPICAL
NOTEAlways install seal with its protector facing the impellerPack seals and bearing with synthetic grease (P293 550 010)
All Models Except HX