Bombardier SeaDoo 1996 factory shop manual, Page 224Get this manual
Section 09 PROPULSION SYSTEM Sub-Section 01 (JET PUMP) F01J0IA
1Bailer tubes 2Water inlet hose
F01J3BA
Secure flywheel guard to engine studs using nut and washer on each side of guardReinstall air vent tube support onto body (SPXP series)
TYPICAL 1Locking disks 2Torque to 20 Nm (15 lbfft)
HX Model Only Make sure rear drive shaft is properly installedInstall jet pumpIf necessary, wiggle jet pump to engage drive shaft splines in impellerInstall flat washers, lock washers and nutsTighten nuts of impeller housing in criss-cross sequence and torque to 31 Nm (23 lbfft)SP GTS and GTI Models ,
be torqued as specified