Bombardier SeaDoo 1996 factory shop manual, Page 222Get this manual
Section 09 PROPULSION SYSTEM Sub-Section 01 (JET PUMP)
Miscellaneous
Generously apply synthetic grease on drive shaft splinesMake sure rubber damper is on drive shaft endsApply Loctite 598 Ultra Black around bailer and water inlet supply fittings1
F05J06A
HX MODEL 1Apply Loctite 598 Ultra Black as indicated by shaded area
Carefully install ride shoe on hullApply Loctite 242 (blue) on screw threads, install and tighten in criss-cross sequenceTorque to 10 Nm (88 lbfin)From inside of bilge, apply 732 sealant (P293 800 006 or293 800 003) on end of screws to completely seal hullApply Loctite 242 (blue) on intake grate screw threads, install and tightenTorque screws to Nm (71 lbfin)