Bombardier SeaDoo 1996 factory shop manual, Page 204Get this manual
Section 09 PROPULSION SYSTEM Sub-Section 01 (JET PUMP)
Pour approximately 90 mL (3 oz) of oil through hole until oil reaches the bottom of hole threadsUse SEA-DOO JET PUMP SYNTHETIC OIL (P293 600 011) onlyOil will drain slowly into center area of housing, wait few minutes and readjust oil levelCAUTIONThis is synthetic oilDo not mix with mineral based oilDo not mix oil brandsApply Loctite PST 592 on plug and reinstall it on coverProperly reinstall removed parts-
JET PUMP REMOVAL
HX Model Disconnect steering cable from jet pump nozzleLoosen hexagonal nuts and remove flat washers and lock washers from jet pump housingRemove jet pumpAll Models Except the HX Remove air vent tube support from body opening (SPXP series)Remove PTO flywheel guardF01I0AA