Bombardier SeaDoo 1996 factory shop manual, Page 131Get this manual
Section 06 FUEL SYSTEM Sub-Section 03 (CARBURETORS)
13, O-ring
When installing O-rings of low speed and high speed screws, apply some BOMBARDIER LUBE (P293 600 016) to prevent sticking
CARBURETOR INSTALLATION
At installation, pay attention to the followingInstall carburetor(s) with gasket(s) to intake manifold (rotary valve cover for the 787 engine)
Single Carburetor Models Only
Install lock washers and apply Loctite 242 (blue) on threads then torque nuts to 25 Nm (18 lbfft)
Twin Carburetor Models Only
Apply Loctite 242 (blue) on screw threadsThen, install screws with lock washers and torque to 20 Nm (15 lbfft)SYNCHRONIZATION OF TWIN CARBURETORS With idle speed screw not touching throttle lever stopper on MAG carburetor, both throttle plates are in closed position
F01F11A
TYPICAL 1Pilot jet 2Gasket 3Main jet 4Check valve housing removed