Bombardier SeaDoo 1996 factory shop manual, Page 129Get this manual
Section 06 FUEL SYSTEM Sub-Section 03 (CARBURETORS)
CARBURETOR ASSEMBLY
When assembling pump, ensure to properly position components togetherRefer to previous illustrations if necessary
6,7, Choke Plate and Throttle Plate
When installing plate onto shaft, close plate so that it centers into carburetor boreFirmly tighten screwsCAUTIONAlways apply Loctite 242 (blue) on screw threads prior to installing screws
F01F0XA
8, Needle Valve Lever
Rounded end of needle valve lever must be flush with surrounding metering chamber floor and not with body assemblyPlace the end of ruler over lever to check adjustment
TYPICAL 1Pump gauge tester 2Install on pulse nipple
Diaphragm must stand pressure for 10 secondsIf pressure drops, replace diaphragm