Bombardier SeaDoo 1996 factory shop manual, Page 98Get this manual
Section 04 ENGINE Sub-Section 05 (EXHAUST SYSTEM)
20, Gasket
Make sure that gasket is properly located on exhaust manifold prior to finalizing pipe installation
4,6,7,8,23, Clamp, Screw and Nut
Apply Loctite 242 (blue) on stud and retaining screw threadsHand-tighten nut and screws and assure that tuned pipe bushing(s) rests against manifoldRefer to the following illustration for the torquing sequence8 2
F01D82A
16, Sealing Ring
HX and XP Model Only Make sure to install the sealing ring on tuned pipe cone if it was removed
F01D0IA