Bombardier SeaDoo 1996 factory shop manual, Page 94Get this manual
Section 04 ENGINE Sub-Section 05 (EXHAUST SYSTEM)
TUNED PIPE REMOVAL
All Models Except HX and XP NOTEFor SP series, remove air vent tube support from body openingDisconnect water inlet hose and water injection hoseDisconnect tuned pipe bleed hose1 3
Remove tuned pipe retaining screw(s) from exhaust manifold side
7,8,9, Screw, Nut and Flat Washer
Remove screws, nut and flat washers from tuned pipe flangeNOTESlightly lift tuned pipe to release nut as necessaryTake care not drop nut and flat washer
11, Tuned Pipe Head
Withdraw tuned pipe in forward and rotating movement
F01D8NA
TYPICAL 1Bleed hose removed 2Injection hose removed 3Inlet hose removed
HX Model Only NOTEIt is possible to remove the tuned pipe head and cone at the same timeIf such is the case, disconnect only the water outlet hose at cylinder head and do not remove the clamp retaining tuned pipe head to tuned pipe coneDisconnect water inlet hose at tuned pipe headDisconnect water injection hose at tuned pipe coneDisconnect bleed hose on top of tuned pipe head