Bombardier SeaDoo 1996 factory shop manual, Page 84Get this manual
Section 04 ENGINE Sub-Section 04 (ROTARY VALVE)
7,8, Snap Ring and Bearing
To remove bearing use bearing extractor such as Snap-on no CJ-950 as illustratedSlide off distance sleeve, remove snap ring and press shaft out
F01J0ZA
Close puller claws so that they can be inserted in end bearingHolding claws, turn puller shaft clockwise so that claws open and become firmly tight against bearingSlide puller sleeve outwards and tap puller endRetighten claws as necessary to always maintain them tight against bearingContinue this way until bearing completely comes out1
F01D4NA
1Bearing 2Bearing extractor Snap-on CJ-950
damage will occur
Ensure that rotary valve shaftCAUTIONperpendicular with press tip or is perfectly