Bombardier SeaDoo 1996 factory shop manual, Page 58Get this manual
Section 04 ENGINE Sub-Section 02 (TOP END)
Warm piston to approximately 50-60C (122140F) and install it over connecting rod Insert extractor spindle into the piston pin, screw on extracting nut Rotate handle to pull piston pin carefully into the pistonF01D0VA
1Thrust washer each side
F01D31A
Insert piston pin into piston until it comes flush with inward edge of piston hub
PLACTIC MOUNTING DEVICE METHOD As an alternate method when no service tool is available proceed as followsReplacement roller bearings are delivered in convenient plastic mounting deviceFor installation, proceed as followsAlign replacement roller bearing with connecting rod bore Carefully push inner plastic sleeve into connecting rod boreouter plastic ring will release rollers1