Bombardier SeaDoo 1996 factory shop manual, Page 44Get this manual
Sous-section 01
Section 04 ENGINE (REMOVAL AND INSTALLATION)
REMOVAL AND INSTALLATION
GENERAL
It is not necessary to remove engine from watercraft for TOP END nor PTO FLYWHEEL AND MAGNETO servicingHowever engine removal is necessary to repair BOTTOM END
All Models Disconnect thermosensor wire and spark plug cablesConnect spark plug cables onto grounding device3
HX Model Only Engine can be removed with jet pump in placeIt is not necessary to perform engine alignment when engine support is not loosen from rubber mountsEngine rubber mounts sit on adapters which can be loosen prior lifting engineIf an engine rubber mount must be replaced, jet pump, driveshafts and seal carrier have to be removed and engine alignment performed
REMOVAL FROM WATERCRAFT
All Models Except HX In order to remove engine from watercraft proceed as followsCAUTIONWhenever removing engine from watercraft, enginejet pump alignment must be performedF01H27B