Bombardier SeaDoo 1994 factory shop manual, Page 207Get this manual
Section 08 PROPULSION AND DRIVE SYSTEMS Sub-Section (PROPULSION AND DRIVE SYSTEMS) 1
- Pressurize pump to maximum of 70 kPa (70 PSI)Pump must maintain thgs pressure for 10 minutes
o oil slowly until
It flows out of ice
Apply Loctite PST 592 on plug threads then secure it on cover
CAUTIONRepair any leak, failure to correct ieak will lead to premature wear of pump :ornponentsIf there is pressure drop spray soapy water around mousing cover If there are no bubbles, impeller shaft, mpeller shaft seal impeller housing is leaking through aorosity and has to be replacedJet pump unit has to ;e overhauled ace hodsing horizontally as 111 its operating position o that fitting in cover is located in top Remove fitting ram cover Pour SEA-DO0 JET PUMP SYNTHETIC 3!L (P 293 600 01 1) in reservoir until oil comes eve1 with bottom of hole Let a penetrates in housing and after few minutes pour oil again until it is level vith bottom of hole Oil capacity is 65 mL (2.2 oz)CAUTIONThis is synthetic oilDo not mix with mineral based oil Do not mix oil brandsNOTE :When filling, oil must be poured into cover quite slowly to aftow complete housing fill