Bombardier SeaDoo 1994 factory shop manual, Page 197Get this manual
Section 08 PROPULSION AND DRIVE SYSTEMS Sub-Section 01 (PROPULSION and DRIVE SYSTEMS)
To remove seal, proceed as follows CAUTIONIt is not recommended push seal out with punchHousing andor bearing(s1 could be damaged
Seal should be removed usmg the following suggested toolSeal pullerSnap-on #S6129
Close puller claws so that they can be inserted between seal and bearingHolding claws, turn puller shaft clockwise so that claws open and tighten against sea!Slide puller sleeve outwards and gently tap puller end Work with small strikes otherwise claws will slip out As soon as seal begins to slide out, retighten claws always maintain them tight against seal Continue pulling until seal is out