Bombardier SeaDoo 1994 factory shop manual, Page 173Get this manual
Sub-Section 06
Section 07 ELECTRICAL (CDI AND CHARGING SYSTEMS)
Most of circuit can be tested with an ohmmeter but 100 test doesn't mean the VTS control module In perfect condition NOTESometimes only parts replacement can solve the problem
(TYPICAL)
CAUTIONWhenever connecting VTS control module, always have battery disconnectedfrom circuitIf VTS control module must be connected when circuit is activated, always connect RED wire
last solenoid positive terminal
BOMBARDIER IGNITION TESTER
The remaining items can be easily checked with Bombardier ignition tester (P295 000 0081
2Follow test procedure sequence 3install cap over safety lanyard switch and aeoress starting button until light turns on, or otherwise for maximum of five seconds4 If engine starts when performing some test, allow I: to idle while observing indicatorThenshut engine off After every test that lights the indicator lamp YESET the indicator circuit by depressing the rese: buttonA000 004 Dl4